Coming a long nice
this stuff is very hard to paint with
I am on the 3rd coat already and at least 1-2 more to go
it’s glossy, and it’s rubbery feeling
its holding up pretty good so far on the card each time I put it back on the card after an hour-2 of letting it dry outside, then cook on the card over night.
Any suggestions on a better way to do this?
Processing your request, Please wait....
Disclaimer: Unless specifically mentioned in the post, we have no clue where this picture came from. Know where it came from? Post the link in the comments, and reap the glory! All comments are the sole possesion of the commenters and do not reflect the opinions or values of MCS.
You can follow any responses to this entry through the RSS 2.0 feed.
You can skip to the end and leave a response. Pinging is currently not allowed.
Loading ...
February 19, 2011 at 2:32 am
There isn’t too much online about this type of modding. The most I can find is the suggestion to use non conductive paint .
Btw will this be covered by your side panel?
February 19, 2011 at 2:23 pm
Technically.
The panel has a 200mm fan with a mesh grill.
I had to take the fan off because the CPU cooler is less than an inch away from the side panel, and the fan is about an inch deep so it would not fit.
You can see the bracket 100% through the mesh grill.
I was thinking about putting a piece of Plexiglas in it’s place.
postimage.org/image/2uuel45k4/
postimage.org/image/2uug8ni1w/